Cameras Settings - Cisco TelePresence MX200 Administrator's Manual

Cisco TelePresence MX200 and MX300
Contents

Cameras settings

Cameras PowerLine Frequency
The video system's camera is able to compensate for any flicker noise from the electrical power
supply (power line frequency anti-flickering). Set this camera configuration based on your
power line frequency. The default value is 50Hz, so you should change this setting if your power
line frequency is 60 Hz.
Requires user role: ADMIN
Value space: <50Hz/60Hz>
50Hz: Use this value when the power line frequency is 50 Hz.
60Hz: Use this value when the power line frequency is 60 Hz.
Cameras PowerLine Frequency: 50Hz
Example:
Cameras Camera [1] Backlight
This configuration turns backlight compensation on or off. Backlight compensation is useful
when there is much light behind the persons in the room. Without compensation the persons
will easily appear very dark to the far end.
Requires user role: ADMIN
Value space: <Off/On>
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
Cameras Camera 1 Backlight: Off
Example:
Cameras Camera [1] Brightness Mode
Set the camera brightness mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set using
the Cameras Camera Brightness Level setting.
Cameras Camera 1 Brightness Mode: Auto
Example:
D14850.10 MX200 and MX300 Administrator Guide TC7.2, AUGUST 2014.
Introduction Web interface System settings System settings
Cameras Camera [1] Brightness Level
Set the brightness level. Requires the Camera Brightness Mode to be set to Manual.
Requires user role: ADMIN
Value space: <1..31>
Range: Select a value from 1 to 31.
Cameras Camera 1 Brightness Level: 20
Example:
Cameras Camera [1] Flip
Not applicable for this product.
Cameras Camera [1] Focus Mode
Set the camera focus mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the
right focus; then auto focus is turned off to prevent continuous focus adjustments of the
camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Cameras Camera 1 Focus Mode: Auto
Example:
Cameras Camera [1] Gamma Mode
This setting enables gamma corrections. Gamma describes the nonlinear relationship between
image pixels and monitor brightness.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref:
Cameras Camera [1..n] Gamma Level.
Cameras Camera 1 Gamma Mode: Auto
Example:
www.cisco.com — Copyright © 2011–2014 Cisco Systems, Inc. All rights reserved.
59
Administrator Guide
Setting passwords Appendices