Remoção E Instalação Do Painel Frontal - Booster BDVM-8360UBT Installation Manual

BDVM-8360UBT INSTALLATION
Removing and Attaching the Faceplate
Removing
Open the front to min 45 degrees or to its fold down position. Gently press the right side towards the left
and gently remove the faceplate by pulling it towards you.
Attaching
Gently place the left side of the front onto the locking pin, then gently click the right side onto the locking
pin and close the front until you hear a click.
CAUTION: DO NOT insert the control panel into the right side. It can damage the control panel. Never
use force or a tight grip onto the buttons or the information display when removing or attaching the
Control Panel. The control panel can easily be damaged by shocks. To avoid damage or potential theft
remove the Control panel, place it into the protective case and be careful not to drop it or subject it to
strong shocks. The rear connector that connects between the main unit and the control panel is an
extremely important part. Be careful not to damage it by pressing on it with fingernails, pens,
screwdrivers, etc.
– 6 –