Booster BDVM-8360UBT Installation Manual page 13

AV IN
Subwoofer
Back View Camera
Auto switch to video
BDVM-8360UBT GENERAL OPERATION
Connect an optional AV cable to your external AV device (such as a video
camera), then press the MODE button to switch to the AV mode. Note: If
there is no external video input, the TFT displays "NO VIDEO SIGNAL".
Connect the subwoofer to the unit using sub output (see wiring
connection). Press MENU button, choose EXPERT and set subwoofer
ON to enable subwoofer.
This unit is equipped with back view camera output. The camera is used to
observe the situation behind the vehicle when you are backing the car.
Please connect your back view camera with the back car video input. And
connect the reverse wire for back a car with the rear gear light. Rear view
camera picture will be enabled when you are backing the car.
To promote safety, certain functions are disabled unless the parking brake
is on. The Unit is designed to detect parked status and must be connected
to the power supply side of the parking brake switch. When playing a
movie file in a driving car, a warning screen will be displayed on the
screen. When the car is placed on the hand brake, the screen will switch to
video automatically. Improper connection or use of his connection may
violate applicable law and may result in serious injury or damage. To avoid
the risk of damage and injury and the potential violation of applicable laws,
this unit is not for use with a video screen that is visible to the driver. Also,
other video displays should not be in a location where it is a visible
distraction to the driver. In some countries or states the viewing of images
on a display inside a vehicle even by persons other than the driver may be
illegal. Where such regulations apply, they must be obeyed and this unit's
movie features should not be used. Note: The supplier waves any and all
liability when these guidelines and warnings are not followed.
– 12–
General Operation