Booster BDVM-8360UBT Installation Manual page 6

Notes on Installation
Note: Step 7 and 8 are only possible when you can reach the back of the unit inside the
dashboard.
Note: Please observe the following safety instructions for the connection of the device:
- Read the entire installation section before connecting the device.
- Disconnect the negative pole of the vehicle battery for the duration of the installation.
- Observe the safety instructions by the vehicle manufacturer during this task.
- If you need to drill holes for the installation, make sure that no parts of the vehicle are damaged.
- The cross section of the positive and negative cable may not be less than 2.5 mm².
Do not connect any of the vehicle‟s plugs and cables to the radio unless you have the appropriate
-
specialized knowledge of this process!
- Depending on the build of your vehicle, the installation may deviate from this description.
- We do not assume any liability for damages caused by faulty installations or connections, nor any
subsequent damages.
- We recommend that you have the device installed by a specialized company. Then you will have
created the prerequisites for a problem-free functioning of the device. If at any point during the
installation you are unsure that you can correctly connect the device by yourself, contact a specialist.
A faulty installation may cause damages to the device and the vehicle electronics.
BDVM-8360UBT INSTALLATION
To remove the unit, CAREFULLY remove the
front rim (do not use force, else the connection
pins of the rim will break off) and place the two
extraction keys into the left and right side of the
unit until they click in place and pull the unit
gently out of the dashboard.
– 5 –