Equinox Systems Cirrus User Manual page 5

Equinox Cirrus
Operation modes:
1, Sound active mode
To Set the Cirrus laser in sound active mode, set the "sound/auto" switch on the rear of the unit to the
Sound position. The laser will now react to the beat of the music. Use the sensitivity control for the
correct sound activation.
2, Auto run mode
To Set the Cirrus laser in auto run mode, set the "sound/auto" switch on the rear of the unit
to the "auto" position. The laser will now run through its built-in programmes.
I.R Remote functions:
To control the Cirrus laser via the I.R Remote, first be sure to remove the plastic battery protector from
the remote control.
Power Button
To turn the unit on, press the "power button". The unit will automatically start in the mode it was last
used.
Pattern Button
To select a pattern, first make sure that the laser is set in auto mode. Now press the "pattern" button to
selects one of the four built-in patterns.
Speed Button
To change the speed of the pattern, press the "speed" button. You can choose from 3 different speeds;
1, Slow, 2 medium,
Colour Button
To select a colour for the desired pattern, press the "colour" button to choose from one of the following
options;
Music:- 1, Red and green (mix), 2, Red only,
Auto:- 1, Red and Green
Music/Auto Button
To select between the Sound active and Auto modes, press the "music/auto" button. The laser will now
react to the desired chosen mode.
Mode Button
This button has no function on this particular model.
3 fast.
3, Green only,
2, Red only 3, Green only
Technical Specifications
4 Red and Green (constant)