Lancia Musa Owner's Handbook Manual page 98

S.B.R. system
The car is fitted with a Seat Belt Re-
minder system (S.B.R.), consisting of
a buzzer and a flashing warning light
<
on the instrument panel which
warns the driver that the seat belt
must be fastened.
The buzzer can be deactivated (until
the next engine stop) as follows:
❒ fasten the driver's seat belt;
❒ turn the ignition key to MAR;
❒ wait for over 20 seconds and then
release one of the seat belts.
For permanent deactivation, contact
a Lancia Dealership.
The S.B.R. can only be reactivated us-
ing the setup menu (see the "Warning
lights and messages" chapter, "Seat
belt reminder" paragraph).
WARNING
Remember that in the
event of a violent collision,
back seat passengers not wearing
seat belts also represent a serious
danger for the front seat passen-
gers.
ADJUSTING THE FRONT SEAT
BELT HEIGHT
(for versions/markets, where provided)
Always adjust the seat belt height to
the passenger's body: this precaution
may considerably reduce the risk of
injury in the event of a collision.
Correct regulation is obtained when
the belt passes approximately half
way between the shoulder and the
neck.
To adjust, move the grip A-fig. 4 of
the locking mechanism either up or
down and at the same time move the
ring B to the most suitable of the al-
lowed positions.
fig. 4
WARNING
The height of the seat belts
must be adjusted with the
car at a standstill.
WARNING
After adjustment, always
check that the cursor to
which the ring is fastened is locked
in one of the set positions. Release
the grip and push downwards to
enable the locking device to click if
the grip has not been released in
one of the possible positions.
L0D0128m
97