Electric Component
7. Remove the DC converter.
DC converter installation
Back to the removal steps.
Removal of DC changeover contactor and
diode assembly
1. Take out the key from the key switch.
2. Apply the parking brake.
3. Remove the seat pad assembly
4. Turn Tow/Run switch to TOW.
Please refer to Chapter 1 "Protection for Electrical
Safety".
5. Remove the watertight cover of DC changeover
contactor①.
6. Remove the lock nut on the binding post of
changeover contactor.
7. Remove the connecting wire, then remove the
diode assembly②.
NOTE:
Keep in mind the polarity of the diode to prevent
incorrect installation resulting in short circuit and
electric element burning out;
8. Remove the DC changeover contactor.
9. Check:
• The continuity of DC changeover contactor coil.
Replace the part in case of un-continuity.
• The continuity of diode assembly.
Replace the part in case of abnormality.、
MERGE 9-11
Chapter 9