Electric Component
8. Turn the switch lever and check the relevant
gears for continuity, replace the part in case of
un-continuity.
Combination switch installation
Back to disassembling steps
Controller removal
1. Take out the key from the key switch.
2. Apply the parking brake.
3. Turn Switch Tow/Run to TOW.
Please refer to Chapter 1 "Protection for Electrical
Safety".
4. Remove the trunk lid.
5. Remove the rear plate plastic screw.
6. Remove the rear plate.
7. Remove the safety belt buckle set bolt
Tightening torque
63N·m(46.5ft·1b)
8. Remove the safety belt buckle
9. Disconnect all wires and multi-wire connectors
from the controller.
MERGE 9-6
Chapter 9