Install - Tomberlin 2010 E-Merge Maintenance Manual

· Remove the oil seal and bearing with the
special bearing puller.
· Install new oil seal cover and bearing in the
installation procedures mentioned above.
NOTICE:
Use a hold-down clamp that is consistent with
the diameter of bearing and inside loop of oil
seal cover.
Caution
Do not knock at the bearing roller and bracket. It
is enough that it reaches the center of the inner
loop.
5. Spindle
In case of damage/deformation, the Spindle is
to be replaced.
6. Front shock absorber
In case of spring deflection/oil leakage and
surface scrape, the front shock absorber is to
be replaced.
7. Swing arm
In case of damage/deformation, the swing arm
is to be replaced.

Install

Move back to the procedures of "removal"
Note the following:
1. Warning
The split pin, once removed, must be replaced
with new one.
2. Install:
· Front wheel
· Wheel nut (of front wheel):
Tightening torque
70N·m (52.0 ft·1b)
EMERGE 5-7
Front Axle
Chapter 5