I Wall-Mounted Type (K Type); Removing The Wall Fixture From The Unit; Selecting And Making A Hole - Sanyo 26 series Installation Instructions Manual

I Wall-Mounted Type (K Type)

3-10. Removing the Wall Fixture from the Unit

KH2672R
Remove and discard the set screws and take off the
rear panel. (Fig. 3-19)
NOTE
K
Tubing can be extended in 3 directions as shown in
Fig. 3-20. Select the direction that provides the shortest
run to the outside unit.

3-11. Selecting and Making a Hole

KH2672R
(1) Remove the rear panel from the indoor unit and
place it on the wall at the location selected. Make
sure the unit is horizontal using a carpenter's level
or tape measure to measure down from the ceiling.
(2) Determine which side of the unit you should make
the hole. (Fig. 3-21)
(3) Before making a hole, check carefully that no studs
or pipes are directly run behind the spot to be cut.
CAUTION
The above precautions are also applicable if tubing
goes through the wall in any other location.
(4) Using a sabre saw, key hole saw or hole-cutting
drill attachment, cut a hole in the wall. See Table
3-3 and Fig. 3-22.
Table 3-3
Hole Dia. (inch)
3-3/16"
(5) Measure the thickness of the wall from the inside
edge to the outside edge and cut PVC pipe at a
slight angle 1/4" shorter than the thickness of the
wall. (Fig. 3-23)
(6) Place the plastic cover over the end of the pipe (for
indoor side only) and insert in the wall.
(Fig. 3-24)
Also avoid areas where electri-
cal wiring or conduits are
located.
Set screws for transportation only
Left-rear tubling
In case of left-rear or right-rear tubing
Center of
left-rear
tubing hole
NOTE
Hole should be made at a slight downward slant to
the outdoor side.
Indoor Outdoor
side side
Fig. 3-22
INSIDE
Plastic cover
(Field supply)
34
Fig. 3-19
Right-rear
tubing
(recommended)
Right tubing
Fig. 3-20
Center of
right-rear
tubing hole
Fig. 3-21
PVC pipe (locally purchased)
Cut at slight angle
Fig. 3-23
OUTSIDE
Wall
PVC pipe
Slight
angle
Fig. 3-24