Metal Valve Body - Audi 100 1991 Repair Manual

Audi 100 1991 ➤ , Audi 80 1992 ➤ , Audi A1 2011 ➤ , Audi A2 2001 ➤ , A ...
Note
Be careful not to scratch off the glued- on wheel trim on these
♦
rims.
The surface of the wheel trim is very sensitive.
♦
The rim will have be replaced if the wheel trim is damaged.
♦
The wheel trim cannot be replaced.
♦
♦ Place wheel on wheel hub and secure it by hand with two
wheel bolts on opposite sides.
♦ Install remaining wheel bolts by hand, they must be easy to
install. Make sure that they are centered exactly.
♦ Take load off wheel if necessary by raising slightly and lightly
tighten two wheel bolts by hand.
♦ When mounting a wheel, tighten all wheel bolts uniformly by
hand.
♦ Tighten the wheel bolts diagonally using, for example, a four-
way lug wrench, to about 30 Nm.
Note
Make sure the correct wheel bolts are installed. Allocation, re‐
♦
fer to the Electronic Parts Catalog (ETKA).
Only the same wheel bolts may be installed on all four wheel
♦
rims for every vehicle.
WARNING
Do not use an impact wrench to install the wheel bolts.
– Lift the wheel slightly to take the pressure off it.
– Lower the vehicle to the floor and tighten diagonally all wheel
bolts to the specified wheel bolt tightening specification.
– Lower the vehicle onto its wheels. Refer to ⇒ Suspension,
Wheels, Steering; Rep. Gr. 44 ; Description and Operation .
5.2

Metal Valve Body

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Special tools and workshop equipment required
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Torque wrench -V.A.G 1410-
♦ 11 m socket wrench -V.A.G 1331-
– Place metal valve with rubber seal through rim from inside.
– Attach chamfered washer and union nut from outside and
tighten by hand.
Wheel and Tire Guide - Edition 11.2010
5. Removal and Installation
87