Audi 100 1991 Repair Manual page 89

Audi 100 1991 ➤ , Audi 80 1992 ➤ , Audi A1 2011 ➤ , Audi A2 2001 ➤ , A ...
– Make sure the contact surfaces -arrow- on the wheel inner side
(rim) as well as the central seat in the rim is free of corrosion
and dirt.
– The spherical caps in the wheel bolt holes must not have any
corrosion, dirt, oil or grease on them.
– If necessary, remove oil, dirt and corrosion and reapply cor‐
rosion protection in centering seat area with Wax Spray -D 322
000 A2- .
Note
The wax spray must not get onto brake system parts.
♦
If rust or dirt falls between brake disc and wheel hub during
♦
removal, remove it by blowing out with compressed air.
DANGER!
Wear protective eyewear when working with compressed air.
The wheel (rim) spherical caps and wheel bolts must be free of
dirt and corrosion.
– Dirty wheel (rim) spherical caps should be cleaned with a lint-
free cloth.
– Check wheel bolts and wheel hub threads for cleanliness.
– Clean dirty wheel bolts in spherical cap area and threads, e.g.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
with a brass brush.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
WARNING
Heavily corroded or damaged wheel bolts must be replaced.
Wheel and Tire Guide - Edition 11.2010
5. Removal and Installation
85