Exit Settings; Factory Reset; Coding Of Remote Controller - Konlen MOBILE CALL GSM Alarm System User Manual

Note: In setting status, press
The system default password is [8888].
Operating method: [ XXXX ]
X indicates the new 4-digit password.
LCD display:

3. Exit Settings

Press [ ] and [#] buttons, the main unit emits a long beep and exits settings.
*
The [ SET ] indicator goes out and the system returns to disarm state.

4. Factory Reset

In disarm status, use keypad to input [95175308246] and press [#] to confirm,
all the LED indicators will be on for 2 seconds and you will hear a long beep.
The main unit gets all its settings cleared and restores to its factory settings
successfully.
Operating method: [95175308246] + [#]

5. Coding of Remote Controller

The remote controller has to be code to the alarm host in order to perform
normally.
In setup state, use keypad to input [20], input the remote controller number
[1~8], and then press [ # ] to confirm. The main unit emits a long beep and
you will hear " remote control coding ". The [
flashing; press any button on the wireless remote controller, the main unit
makes a long beep and you will hear "coding completed", [
goes out, indicating the remote controller succeeds in coding.
Operating method: [20]
A indicates: 1~8 remote controllers number.
5
can delete the numbers input.
[#]
#
*
[A] [#]
Functions Settings
Functions Settings
] indicator is on without
] indicator