DataCard SR200 Installation Manual page 68

5.
Change the unit number at the printer LCD panel.
a.
Press Menu to enter the menus.
b.
Press Next several times until Setting is displayed.
c.
Press Enter to open the Setting menu.
d.
The first submenu is Display. Press Next twice.
e.
Unit No. is displayed. Press Change.
f.
Press the down arrow key to scroll to the desired unit number.
To select a lower number, scroll to 10 and then press the down arrow
key again. The number rolls over to 1.
g.
Press the Return key to assign the number.
h.
Press Exit twice to leave the menus.
i.
Power off the printer. Wait 30 seconds or more. Power on the
printer.
6.
Open the Status Monitor as an administrator‐level user.
Refer to the "Using the Status Monitor" section of the
User's Guide. Click the Printer Select tab.
7. Make sure that the identifier from step
Current Printer field. Click Refresh to get the new unit
number from the printer.
8.
Change the Printer Name field to correspond with the unit
number. For example, if you set the unit number to 8,
change the printer name to PRINTER08.
9.
Change the Default Interface value and network settings, and change if needed.
If the printer is set to USB and you plan to install the printer with a network connection,

change the value to Network.
60
4 is selected in the
Installing the Status Monitor