DataCard SR200 Installation Manual page 18

c.
Install the card stacker.
d.
Connect the power cord to the printer and to the laminator (if used). Power on both
devices and then power off again.
e.
Install printing and laminating supplies (ink ribbon, retransfer material, laminator film
cartridges, and cards).
3.
Use the Installation CD to install the SR‐CP printer driver onto the PC. (Both the network and
USB cables will be connected during this step.)
4.
Use the Installation CD to install the Status Monitor onto the PC.
5.
Power on the printer and configure the connection between the PC and the printer.
If necessary, use the PC to assign the Datacard SR‐CR retransfer printer plug‐in to the printer,
and to set up the unit number and printer name. Set the default interface value to Network.
6.
Power off the printer and disconnect the USB cable. Use the network cable to connect the
printer to your local network.
7.
Reinstall the printer driver using the network cable.
8.
Assign the printer's IP address, if necessary.
9.
Set up IP security, if needed, using either a printer certificate or a preshared key.
10.
Set up printer sharing, if desired.
10
Caution: Do not connect the USB or network cable to the printer and PC yet. The
printer driver must be installed first to enable communication between the
components.
Planning the Installation