Depth - Invacare Pronto M91 Service Manual

Depth

NOTE: For this procedure, refer to FIGURE 7.3.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
Make sure the detent balls are engaged with the outer edge of the tube - otherwise,
injury and/or damage may result.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls are engaged with the outer
edge of the tube (Detail "A" of FIGURE 7.3).
Mounting
Hole
Three
Depth
Adjustment
Holes
Detent Ball
Quick Release Pin
FIGURE 7.3 Adjusting the Footboard Assembly - Depth
Part No. 1125038
WARNING
Wheelchair Frame
Footboard Assembly
SECTION 7—FOOTBOARD ASSEMBLY
DETAIL "A" - Bottom View of
Quick Release Pin
Outer Edge of Tube
63
Footboard
Detent Balls
Pronto® M91™ and M94™