Removing/Installing The Adjustable Height Tubes - Invacare Pronto M91 Service Manual

Removing/Installing the Adjustable Height Tubes

NOTE: For this procedure, refer to FIGURE 4.5.
NOTE: Reverse this procedure to install the adjustable height tubes.
1. Remove the top shroud from the wheelchair. Refer to Removing/Installing the
Shrouds on page 71.
2. Remove the mounting screw and locknut securing the front adjustable height tube to
the front support tube.
3. Remove the front adjustable height tube from the front support tube.
4. Remove the mounting screw and locknut securing the rear adjustable height tube to
the rear support tube.
5. Remove the rear adjustable height tube from the rear support tube.
Rear Support Tube
Mounting Screw
FIGURE 4.5 Removing/Installing the Adjustable Height Tubes
Part No. 1125038
Rear Adjustable Height Tube
Locknut
Locknut
37
SECTION 4—SEAT
Front Adjustable Height Tube
Front Support Tube
Mounting Screw
NOTE: M94 shown.
Pronto® M91™ and M94™