SECTION 6—FRONT RIGGINGS
Adjusting Footrest Height
Model PHWH93
NOTE: For this procedure, refer to FIGURE 6.2.
1. Remove any accessories from the footrest(s).
2. Remove the footrest from the
wheelchair. Refer to Installing/
Removing Front Riggings on page 55.
NOTE: Lay footrest on a flat surface to simplify
performing procedure.
3. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
4. Reposition the lower footrest to the
desired height.
5. Reinstall hex bolt, coved washers and
locknut that secure lower footrest to
footrest support. Tighten securely.
6. Repeat STEPS 1-5 for the opposite footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front
Riggings on page 55.
8. Reinstall any accessories onto the footrest(s).
Model PH904A and PHAL4A
NOTE: For this procedure, refer to
FIGURE 6.3.
NOTE: PH904A style front rigging shown.
PHAL4A front rigging adjusts the same way.
1. Loosen, but do not remove the lug bolt
and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest
support.
4. Repeat STEPS 1-3 for the opposite footrest, if necessary.
Pronto® M91™ and M94™
Locknut
Coved
Washer
FIGURE 6.2 Adjusting Footrest Height -
Model PHWH93
Footrest
Support
Lug Bolt
Lower
Footrest
FIGURE 6.3 Adjusting Footrest Height -
Model PH904A and PHAL4A
56
Footrest
Support
Coved Washer
Hex Bolt
Lower
Footrest
Locknut
Part No. 1125038