Control Specifications - Sanyo SPW-C1155DXHN8 Technical Data & Service Manual

2. Indoor Unit
2-2. Control specifications
Unit specifications
MICROCOMPUTER CONTROL
Thermal modulation
Setting
Alarm display (*2)
Heating Preparation
Defrosting
Service functions
System Control
Other
Rated conditions
* 1. Only when all indoor units have an identical refrigerant system inside and the units are in the same group control system.
* 2. Please refer to the "Meaning of Alarm Messages" in section 5.
Preset temperature range
Transpiration temperature control
preset value
Mode change
Fan speed
Timer
Serial communication errors or
setting errors
Unregistered settings or setting
errors
Safety device errors
Thermistor trouble, etc.
Compressor cover
Indoor fan speed control
Please refer to the service technical data of combined outdoor units.
Temperature sensor indicator
function
Service check (archival record)
indicator function
2 remote-controls
Group-control
Test run Forced thermo ON
4-29
W-2WAY ECO-i SYSTEM Unit Specifications
Cooling 18 °C – 30 °C
Heating 16 °C – 30 °C
Auto 17 °C – 30 °C
Cooling
Heating
Auto (*1), Heating, Cooling
OFF, ON, OFF Repeat
When the indoor heat exchanger
temperature is below 28 °C, below
25 °C is rated wind velocity and
below 1 °C the wind stops. (Max.
length of 6 min.)
All temperature sensors are call
ready.
Records up to 4 service checks in
the order of the occurrence.
2 remote-controls connected (One
as a main remote-control, and one
as secondary remote-control.)
Up to 8 units can be operated at
once.
Room temperature settings are
bypassed with forced operation.
12 °C
40 °C
Constant
E**
L**
P**
F**
H**
1
2
3
4
5
6
7
8