Sanyo SPW-C1155DXHN8 Technical Data & Service Manual page 89

4. System Controller
D: ON button
E: OFF button
F: Operation lamp
G: MODE button
H: Temperature setting
buttons
I: FAN SPEED button
J: FLAP button
CAUTION
This button is for turning the selected air conditioner on.
This button is for turning the selected air conditioner off.
This lamp lights when the unit is turned on.
Use this button to select one of the following 5 operations:
(AUTO) : Used to automatically set cooling or heating operation.
Only for heat pump type
(HEAT)
: Used for normal heating operation.
Only for heat pump type
(DRY) : Used for dehumidifying without changing the room temperature.
(COOL) : Used for normal cooling operation.
(FAN) : Used to run the fan only, without heating or cooling operation.
When the indication is displayed, you cannot change the mode from
NOTE
or to or and . To change the mode, turn off all units once then select the
mode again.
: Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.
(AUTO) : The air conditioner automatically decides the fan speed.
(HI) : High fan speed
(MED) : Medium fan speed
(LO) : Low fan speed
1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
Operation mode
(COOL) or
(HEAT) or
(AUTO)
Cooling mode:
Heating mode:
In the Cool mode and Dry mode, when the flaps are set in a
downward position, condensation may form and drip around the
vent.
Do not move the flap with your hands.
This function is available only for models X, T and LD.
NOTE
2. Use this button to make the airflow direction sweep up and down automatically.
( )
Press this button several times until the (
This function is available only for models X, K, T and LD.
NOTE
1) The flap setting can be performed only for units that have no remote controllers.
NOTE
2) In the ALL or ZONE mode, no flap setting can be performed. If necessary, you
should select the GR mode and use the FLAP button.
3-43
Control of W-2WAY ECO-i SYSTEM
(Temperature range: 17 to 27°C)
(Temperature range: 16 to 26°C)
(Temperature range: 18 to 30°C)
(Temperature range: 18 to 30°C)
Number of airflow direction settings
(DRY)
(FAN)
) symbol appears on the display.
and
3
5
3
5
1
2
3
4
5
6
7
8