Sanyo SPW-C1155DXHN8 Technical Data & Service Manual page 69

2. Wireless Remote Controller
2-21. Wiring the Separate Receiver Unit
* Use wires that are 0.5 mm
* The wiring length must not exceed 400 m.
<Flush Mounting>
Connection diagram
Wire of receiver unit
Provided
(field supply)
wire joint
(WHT 2)
Power wire from
receiver unit
Wire joint
CE-1 (provided)
<Exposed Mounting>
Connection diagram
Use the remote controller cord (optional) for wiring the
separate receiver unit.
1. For the methods used to install the remote controller cord,
refer to "For flush mounting into a wall, install the sepa-
rate receiver unit in a metal switch box (field supply) that
has been recessed into the wall in advance" on P. 3-21.
2. When using the remote controller cord (optional), refer to
the instruction manual that came with the cord.
Check the terminal number on the indoor unit before wir-
ing the remote controller and be sure not to wire incor-
rectly. (The unit will be damaged if high voltage, such as
200 VAC, is applied to it.)
2 2
– 2 mm in diameter.
Indoor unit
remote controller
terminal board
1. Strip the insulation to approximately 14mm
from the ends of the wires to be connected.
2. Twist together the 2 wires and create a
crimp connection at the wire joint.
3. If a special crimping tool is not used, or if
the connection is soldered, insulate the
wires using insulation tape.
Indoor unit
1
remote controller
2
terminal board
Remote controller cord (optional)
1
WHT
1
2
2
BLK
Power wire from
Wire of
receiver receiver unit
unit (field
Connector
supply)
WHT
1
Separate
receiver unit
2
BLK
3-23
Control of W-2WAY ECO-i SYSTEM
Separate
receiver unit
1
2
3
4
5
6
7
8