Parts Supplied With Simplified Remote Controller; Simplified Remote Controller Installation Guidelines; How To Install The Simplified Remote Controller - Sanyo SPW-C1155DXHN8 Technical Data & Service Manual

6. Simplified Remote Controller
Parts Supplied with Simplified Remote Controller
Supplied parts
No.
Simplified remote
controller
1
(comes with
200 mm wire)
Machine screws
M4 25
×
2
Wood screws
3
Simplified Remote Controller Installation Guide-
lines
1
Place of installation
Mount the simplified remote controller at a height of 1 to
1.5 meters above the floor where it can sense the average
temperature of the room.
Do not mount the simplified remote controller in a place
2
exposed to direct sunlight or a place exposed to outside
air such as near a window.
Do not mount the simplified remote controller behind an
object so that it is separated from the air circulation of the
room.
Mount the simplified remote controller within the room be-
3
ing air conditioned.
The simplified remote controller must be mounted on the
wall or other surface vertically.
SWITCHING THE ROOM TEMPERATURE SENSOR
The room temperature sensor is placed both in the indoor unit
4
and the simplified remote controller respectively. Either sensor
can be used to sense the room temperature. The indoor unit
sensor is usually used.
If you use the simplified remote controller to sense the room
temperature, switch the remote controller sensor switch (RCU.
SNS) on the P.C.B. of the simplified remote controller from
5
OFF to
ON. See the diagram below.
<NOTE 1 > Even though the simplified sub-remote controller
switch is switched from OFF to ON, the sub-
remote controller cannot detect the room
6 temperature.
< NOTE 2 > The standard remote controller cannot detect the
room temperature.
7
8
Supplied parts
Qty No.
Spacers
4
Wire joints
2 5
Installation manual
2 6
Fig. 3-55
Control of W-2WAY ECO-i SYSTEM
Qty
2
5
1
How to Install the Simplified Remote Controller
< NOTE 1 > Do not twist the simplified remote controller wir-
ing with the power wiring or run it in the same
metal conduit, because this may cause malfunc-
tion.
< NOTE 2 > Install the simplified remote controller away from
sources of electrical noise.
< NOTE 3 > Install a noise filter or take other appropriate
action if electrical noise affects the power supply
circuit of the unit.
* Use an electric junction box (supplied locally) (Fig. 3-56)
for flush mounting of the simplified remote controller.
Under case (back case)
Simplified remote controller
3-94
Spacer
Electric junction box
for one box (no cover)
Machine screws
×
M4 25 (2)
Fig. 3-56
Wall