How To Wire The Remote Sensor; Important Information When Using Together With Remote Controller Switch - Sanyo SPW-C1155DXHN8 Technical Data & Service Manual

7. Remote Sensor

How to Wire the Remote Sensor

Connection diagram
Terminal
block
for wiring the
remote
controller of
the indoor unit
* 1: 0.5 mm
How to connect lead wires
2 supplied
Lead wire from
white wire
indoor unit
joints
Lead wire
from remote
sensor

Important Information When Using Together with Remote Controller Switch

Installation method
1. Set the remote controller switch as the main remote controller.
<NOTE > Do not set the room temperature sensor on the remote controller switch as the remote
controller sensor.
Basic wiring diagram
<NOTE > When connecting the wires, be careful not to wire incorrectly.
(Incorrect wiring will damage the unit.)
* Wiring when controlling a single indoor unit with the remote sensor and remote controller switch:
1
2
*1
Wiring for remote sensor
(supplied locally)
2 2
to 1.6 mm wires are used for lead wires.
1. Peel off 14 mm of the
cab le sheathing.
2. Twist the 2 wires together
and crimp them together
with the wire joint.
3. When a crimping tool is
not used, solder the wires
Wire
together and cover the
joint
joint with insulating tape.
Remote sensor
1 2
2-pin terminal block
for remote controller
wiring
Earth
3-99
Control of W-2WAY ECO-i SYSTEM
1
WHT
2
BLK
Wiring from remote
Connector
sensor
Fig. 3-64
Fig. 3-65
Remote controller
switch (main)
(Option)
1 2
Remote controller wiring
1 2
(field supply)
Indoor
unit
Fig. 3-66
Remote
sensor
1
2
3
4
5
6
7
8