(2) Installation
Remove all shipping materials before installation.
Caution: Make sure the copier is unplugged before installation.
Location
1
2
2
3
6-20
Shipping material/Procedure
1
(1) Install the SIMM PCB onto the
printer controller PCB. (outer slot).
(2) Install the mounting bracket.
(2 screws)
(3) Install the printer memory.
2
(1) Remove the copier rear cover.
(7 screws)
(2) Remove the blind plate.
(1 screws)
(1) Install the controller cooling fan
onto the printer controller mount-
ing bracket. (Use upper side of the
holes.) (2 screws)
Note: Make sure that the label on
the cooling fan is facing to-
wards the rear side of the
machine.
(2) Connect the cooling fan harness.
(3) Install the harness in the locking
wire saddle.
Check