Auto Connection; Bluetooth Connection From Idle; Mode; Device List And Connection - AT&T CLP99183 User Manual

Bluetooth
Bluetooth setup

Auto connection

When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the
device. When the device moves out of range, it is disconnected. Your device
might make a connect or disconnect sound.
A connected device could also be disconnected by:
• Turning off the Bluetooth device.
• Turning off the Bluetooth feature of the device.
Disconnecting through the telephone base Device list. If you disconnect
•
through the Device list, the telephone base will not attempt to reconnect
until your device is moved out of range and then moves back in range again.
Bluetooth connection from idle mode
When you have active devices that are not connected,
on the telephone base in idle
active device. When there are two active devices, the screen will prompt you
to choose one before connection.

Device list and connection

Up to 4 devices can be paired to the telephone base. All paired devices
are shown on the device list. To use a paired device, it must be in an active
slot (D1: or D2:) on the device list and connected. Both Bluetooth enabled
devices can be used on a cell call at a time
Once you have paired a device with the telephone base, you do not need
to repeat the pairing procedure again unless you delete the device from the
device list.
NOTE: When connecting a Bluetooth device to the device list, all connected devices will
be temporarily disconnected until the procedure is complete. It may take up to 2 minutes
to reconnect.
mode. Press CONNECT
24
CONNECT
appears
to start connecting an