Table of Contents
Advertisement
n. TeST run The ChaSSIS
operate pendant control to verify that the stair lift
will go up and down properly, while holding the
seat swivel switch in.
readjust the tracking rollers, if necessary. refer
to step J.
o. leVel The SeaT hub
Loosen the three (3) bolts on the chassis
behind the footrest.
Place a torpedo level on either the seat hub
or the footrest.
Rotate mounting bracket on the bolts until the
seat mounting shaft is vertical and plumb.
Footrest
Note: If you run out of slot, remove the bolts and replace them
in different holes until the seat will plumb to vertical.
Tighten the bolts.
It is very important to torque the nuts to a minimum of
18 ft. lbs. (24.4 Km) to lock the seat hub into place.
Bolts
p.
InSTall The SeaT
place the seat assembly onto the seat shaft.
rotate the swivel seat handle and slide the seat fully
onto the shaft. release the handle and make sure the
seat locks into position.
rotate the swivel seat handle and check that the seat
locks in the loading, riding, and unloading positions.
citia or
aveya seat
seat handle
seat post collar
locking mechanism
seat post
Note: The swivel handle is installed on the right hand side
of the seat. If desired, the handle can be moved to
the left-hand side. Refer to the assembly drawing
in the Service Information section for assistance.
locking mechanism
seat post
15
Hide quick links:
Advertisement
Table of Contents
