Table of Contents
Advertisement
I.
InSTall FleX ChaIn
determine whether the installation is to be a right
or left hand installation. The flex chain is factory
configured for a right hand installation. For left hand
installations the flex chain must be remounted on
the mounting bracket.
M easure the full length of track. The flex chain must
be shortened to the same length. chain links can
be removed by snapping links apart. reinstall the
end mounting link to chain. When reinstalling the
end mounting link route the wire as shown.
Note the power wire comes throught the flex-
chain and exits before the last link. The wire is
then on the top of the last link
chain mounting clip
Install the chain mounting clip with the two philips
head screws located at the end of the Flex chain.
connect the three wire leads protruding from
the bottom of the chassis's switch plate to the
corresponding wire leads found at the bracket
mounted end of the flex chain. Each wire lead has
a corresponding match paired connector, i.e., it will
only fit with the correct wire.
wires from
chassis
The chain mounting clip
installs here.
wires from
flex chain
These screws hold the mounting
bracket to the chassis.
‘
determine which end of the chassis will be the "downhill"
end. When folded, the folded loop of the flex-chain must
be toward the "downhill" end of the chassis. remounting
the flex-chain to the opposite end of the bracket may
be required
Flex Chain
The chain only bends one way, so make sure that the
loop is heading ouT of the end that will be heading
doWn.
The Chain will fit like this:
Flex Chain
face of screws
holding Flex-
chain to mounting
bracket are
pointing down
towards gear.
Center Channel
of Citia track
Center Channel
of Citia track
11
Hide quick links:
Advertisement
Table of Contents
