Lionel FireCarwith Training/Support car Owner's Manual page 12

TrainMaster Command operations
Assigning your locomotive a new ID#
Example
Command Base ON
Place the locomotive on track
PowerMasters set to CMD or
traditional power supplies ON FULL
Set the locomotive reverse unit control
switch to PROGRAM (see below for location)
Turn track power on (PowerMasters):
Press BOOST
Program the locomotive with a new ID#:
Press ENG
Press a number you choose
(the ID#)
Press SET
Set reverse unit control switch to
FORWARD/RUN (see below for location)
Your locomotive remembers its ID# forever;
change it any time with these steps
Set the Firecar set's reverse unit
program switch to PROGRAM.
When you've finished program-
ming the ID#, set the switch to
RUN.
12
12
Assign a new I D# to your
Command-equipped
locomotive
Prog
Signal
A
s your fleet of Command-equipped
Lionels grows, give your Firecar set
locomotive its own ID#. Choose from
any between 1 and 99. Turn the
Command Base O
motive on track. Power up, then slide
the locomotive's reverse unit control
switch to PROGRAM.
Using CAB-1, press ENG, the locomo-
tive ID#, then press the SET button
located under CAB-1's removable panel.
Hear the locomotive's horn sound (if
RailSounds is on); that's your signal that
the programming has been accepted.
Slide the control switch to RUN.
We recommend that you choose an
easy to remember ID# for your
engine. Some possibilities are part of
the engine road number, your age,
any two digit number that is not
used by another engine. If you like
write the number on a small piece of
tape and put this on the bottom of
the frame to aid in remembering.
LCRU
Run
RailSounds
Full
Railsounds volume control
and place the loco-
N
Front of Training/Support car
adjustment knob