Konica Minolta bizhub 362 User Manual page 21

2
4
Touch [Enter].
What happens if a wrong Administrator Code (Administrator Pass-
?
word) is entered?
% If a wrong Administrator Code (Administrator Password) is entered,
a message appears saying that the password entered is wrong. En-
ter the correct Administrator Code (Administrator Password).
% If the Enhance Security function is set to [ON], entry of a wrong
password is counted as unauthorized access. If a wrong Adminis-
trator Code (Administrator Password) is entered three times, a mes-
sage appears that tells that the machine accepts no more
Administrator Codes (Administrator Passwords) because of unau-
thorized access for any subsequent entry of the Administrator Code
(Administrator Password). The machine is then set into an access
lock state. To cancel the access lock state, turn off, and then turn
on, the main power switch of the machine. When the main power
switch is turned off, then on again, wait at least 10 seconds to turn
it on after turning it off. Be sure to allow an interval of 10 sec. or
more in order to ensure correct operations.
Here is the sequence, through which the main power switch and
sub power switch are turned on and off:
Turn off the sub power switch → Turn off the main power switch →
Turn on the main power switch → Turn on the sub power switch
5
Press the [Reset] key to log off from the Admin. Management mode.
2-4
Administrator Operations
362/282/222