Baldor Modbus Plus Installation And Operating Manual page 33

H Series – Fault Message Description
Fault Message
µp Reset
ROM Fault
1 Min Overload
No I Feedback
New Base ID
EXB Selection
Power module
Co–processor
Software
Version
Feedback
Module
Serial watchdog
FLT Network
Hardware
Protect
Unknown FLT
Code
Bus Current
SENS
Note These faults may be different for custom software.
5-12 Software Setup
Fault Code
15H 18H
22 22 A software watchdog timer has reset the
processor because a process has timed out.
23 ROM checksum error.
24 24 Peak output current exceeded the 1 minute
rating value.
25 Loss of current feedback
26 26 Control board detected a change in the Power
Base ID value in software.
27 27 Expansion board not installed to support the
Level 1 Input Block, Command Select
parameter.
28 Power module failure.
29 Co–processor error (i.e. DSP board).
30 Wrong control software version detected.
31 Feedback HW module failure.
32 Serial port transmit/receive error
33 33 Lost network communications.
54 A general hardware fault was detected but
cannot be isolated.
55 34 Microprocessor detected a fault that is not
identified in the fault code table.
56 Failure to sense bus current.
Continued
Fault Description