Baldor Modbus Plus Installation And Operating Manual page 23

Action
Press Y
Scroll to Serial mode
or B key
Press Saves mode change value
Enter key
Press Y
Scroll to Command Select
key parameter
Press Flashing cursor indicates
Enter key mode can be changed
Press Y
Scroll to Serial mode
or B key
Press Saves change to serial
Enter key command select
Press Y
Scroll to Level 2 blocks
or B key
Press Select Level 2 blocks.
ENTER
key
Press Y
Scroll to Communications
or B key
block
Press Select Level 2
ENTER Communications block.
key
Press Flashing cursor indicates
Enter key mode can be changed
Press Y
Scroll to RS 485 BBP
or B key
(Baldor Binary Protocol)
Press Select RS 485 BBP mode.
ENTER
key
Press Y
Scroll to Exit Menu
or B key
Press Returns to Display mode.
DISP key
Press Changes to Serial
LOCAL Operation.
key
Note: The 15H control does not have a Command Select "Serial",
this is not needed for this control.
The control is now configured for Modbus Plus mode and the Host
software can now be setup.
5-2 Software Setup
Description Display
OPERATING MODE
SERIAL
OPERATING MODE
P: SERIAL
COMMAND SELECT
P: +/–10VOLTS
COMMAND SELECT
+/–10VOLTS
COMMAND SELECT
SERIAL
COMMAND SELECT
P: SERIAL
PRESS ENTER FOR
LEVEL 2 BLOCKS
PRESS ENTER FOR
OUTPUT LIMITS
PRESS ENTER FOR
COMMUNICATIONS
PROTOCOL
p: RS232 ASCII
PROTOCOL
RS232ASCII
PROTOCOL
RS485BBP
PROTOCOL
p: RS485BBP
PRESS ENTER FOR
MENU EXIT
STP MOTOR SPEED
LOCAL 0RPM
STP MOTOR SPEED
SERIAL 0RPM
Comments
Change to
Serial mode.
Now in ±10 Volt
input mode.
Change to
Serial mode.
Control is now
in Serial mode.
First screen in
Level 2 block
Display mode.
Ready for
Modbus Plus
operation.