Ending The Charging Process - Sunrise Medical Quickie Xtender User Instruction Manual & Warranty

X V . B a t t e r y
Unsuitable battery temperature
• The first, third and fifth LEDs flash. Although it is possible to use the battery,
we recommend that you do not operate the wheelchair until the temperature
has returned to the normal range. Remaining battery capacity will not appear
in the display.
• If the battery has reached a suitable temperature, lights 1, 3 and 5 stop flash-
ing and the battery capacity is shown again.
Battery fuse blown or contact error
LED 3 flashes. See the "Troubleshooting" section for details about problems
arising during charging under the header "Charging".
I. ENDING THE CHARGING PROCESS
1. Remove the charged battery after completing the charging process.
Remember to replace the protective cap on the battery before storing it.
Unprotected contacts can lead to a short circuit.
2. Remove the plug from the socket.
IMPORTANT– Do not pull by the cable itself as this could cause damage.
3. Long-term storage of the battery.
Long-term storage of the battery reduces its capacity through spontaneous dis-
charge. Fully charge the battery before you store it long-term and avoid rooms
where the temperature is too high.
4. Recycling the battery
A battery which has reached the end of its life and which cannot be used any
longer, is still a resource of valuable material.
39
930547 Rev. C