Checking The Battery; When A Battery Is Installed In The Charger - Sunrise Medical Quickie Xtender User Instruction Manual & Warranty

X V . B a t t e r y
E. CHECKING THE BATTERY
The battery capacity is shown when the display key is pressed. The total capacity is
indicated on the LEDs in increments of 20%.
The display is active for app. 5 seconds.
1. Reading the display
If the battery is used constantly from a fully charged state, the number of illuminated
LEDs is reduced one by one.
The remaining capacity of the battery is displayed.
2. Timing of charging
The battery capacity is low. Charging should take place soon. (Operation is still possi-
ble for a while).
3. Charging should begin now.
The remaining battery capacity is very low. Using the power assist drive is only possi-
ble for a short distance. Get the wheelchair to a safe place and change the battery or
charge it immediately.
IMPORTANT– When changing the battery make sure the brakes are engaged
on both wheels.
F. WHEN A BATTERY IS INSTALLED IN THE CHARGER
1. During a quick-charge
• When the charging process starts, the capacity display is automatically activat-
ed and indicates the progress of the charging process.
• At the end of the charging process the capacity display automatically goes out.
Reading the display
Permanently illuminated LEDs indicate the level of charging capacity. A flashing LED
shows that charging is in progress.
Full capacity has almost been reached. Charging will shortly finish.
2. During Refresh-charging
• When Refresh-discharging begins, the capacity display LEDs go out one after
another. Discharging the battery reduces its capacity to zero.
• When the Refresh-discharge is complete, charging begins automatically. The
display now changes to quick-charge mode.
Reading the display
The flashing LED on the capacity display indicate the remaining capacity of the battery.
The Refresh-discharge process will soon be complete and the charger switches to
charge. Charging will be complete in app. 4 to 6 hours.
37
930547 Rev. C