Honeywell Ademco Vista-48LA Installation And Setup Manual page 27

Table of Device Addresses
This Device
RF Receiver
Alternative Communication
†
Media (ACM)
Telecommand Voice Module
Zone Expanders** (4219/4229):
module 1 (zones 09 - 16)
module 2 (for zones 17 - 24)
module 3 (for zones 25 - 32)
module 4 (zones 33 - 40)
module 5 (zones 41 - 48)
Relay Modules (4204/6164):
module 1/6164 relay only
module 2/6164 relay only
module 3/6164 relay only
module 4/6164 relay only
Keypads:
keypad 1
keypad 2
keypad 3
keypad 4
keypad 5
keypad 6
keypad 7
keypad 8
5800TM Module
† ACM devices include: 7845i Ethernet Interface Internet/Intranet, AI4164RS/AI4164ETH RS485/Ethernet Eureka Network
Interface
†† Addressable devices are identified by "1" plus the device address when reporting. Enter a report code for zone 91 to enable
addressable device reporting (default = reports enabled). See field *199 for addressable device (ECP) 3-digit/2-digit
identification keypad display options.
** or 6164 Keypad using zones; address 07 = zones 9-12, 08 = zones 17-20, 09 = zones 25-28, 10 = zones 33-36, 11 = zones 41-44
††
Uses Address Reports as
00 100
03 103
17-23 117-123
07 107
08 108
09 109
10 110
11 111
12 112
13 113
14 114
15 115
16 116
17 117
18 118
19 119
20 120
21 121
22 122
23 123
28 n/a
Enabled By...
*56 zone programming: input device type entry
automatic if output to ACM field *29 enabled
same as keypad enables; see below
*56 zone programming: input device type entry, then:
automatic if zone no. 9-16 entered as AW type or relay assigned
automatic if zone no. 17-24 entered as AW type or relay assigned
automatic if zone no. 25-32 entered as AW type or relay assigned
automatic if zone no. 33-40 entered as AW type or relay assigned
automatic if zone no. 41-48 entered as AW type or relay assigned
*79 output device programming: device address prompt:
entered at device address prompt
entered at device address prompt
entered at device address prompt
entered at device address prompt
data field programming as listed below:
always enabled for partition 1, all sounds enabled.
data field *190
data field *191
data field *192
data field *193
data field *194
data field *195
data field *196
automatic
3-7