Meter Config Command - Speedtouch IPQoS Configuration Manual

Chapter 6
Meters, queues and IPQoS

6.4.1 Meter config command

Meter parameters
Meter config
parameters explained
68
The table below shows all the parameters that can be configured by using the
meter config
Parameter
name
label
intf
droprate
markrate
burst
dropaction
markaction
tosmarking
tos
dscp
precedence
classification
class
In this section we will explian the meter parameters in detail and how to configure a
meter.
Name
name value
string
Label
label value
BE, DSCP, EF,
Interactive,
Management, etc
command.
Description
The name of the IPQoS meter.
The name of the label.
The name of the interface.
The drop rate in kilobits per second (Kb/s).
The mark rate in kilobits per second (Kb/s).
The burst size in kilobytes (KB).
The drop action.
The mark action.
Enable tos marking for marked packets.
The type of service used for tos marking.
The diffserv code point (part of tos, used for tos-marking).
The precedence (part of tos, used for tos-marking).
The type of classification for marked packets.
The class or offset used for classification.
Description
This is the name of the IPQoS meter.
Description
The label to which the meter applies.
E-NIT-CTC-20041213-0013 v0.5