Ef Timers - Speedtouch IPQoS Configuration Manual

6.3 EF timers

The ef command group
Configure the ef timer
The ef config
parameters explained
Intf
State
E-NIT-CTC-20041213-0013 v0.5
The ef command group is used to change EF specific parameters on a per-interface
basis.
By using the command the following parameters can be configured :
config
Parameter Description
intf The IP interface name.
state Enable, disable IPQoS EF timer for the interface.
timeout The timeout in miliseconds before the MTU goes back to the
original value.
mtu The MTU of the IP interface in case of EF data.
To change the configuration of the EF timer issue the following command:
{Administrator}=>:ipqos ef config intf my_pppoe state enabled timeout
2000 mtu 500
In this section we will explain the parameters in detail and we will have a look at the
values that can be used.
intf values
loop
pppoe, pppoa,...
LocalNetwork
state values
Enable
Disable
Description
This is the loopback interface of the SpeedTouch™
These are the possible connections to the WAN.
This is the LAN to modem gateway interface.
Description
Enable MTU lowering for the interface.
Disable MTU lowering for the interface.
Chapter 6
Meters, queues and IPQoS
63