Quick Start Setup - EverFocus ENR 400 Installation Manual

ENR 400 Installation Manual

5.3 Quick Start Setup

This chapter describes the minimum installation steps to install IP-cameras for standard (continuous) recording.
Note: Precondition for this quick start setup is that all IP cameras of the system are installed in the same network
and IP address range as the ENR. The default IP setting of the ENR is DHCP mode with alternative IP
setting (if the network doesn't support DHCP):
IP: 192.168.1.100
Subnet mask: 255.255.0.0
1. Open camera setup menu >CONFIG > SETTING > tab CAMERA:
After selecting the tab CAMERA, the screen shows the camera setup with an empty camera list.
The camera setup supports 2 methods to install cameras:
12 of 81 ENR400_ma_inst_en_rev01