Setting - Hotline (Communication Settings) - EverFocus ENR 400 Installation Manual

ENR 400 Installation Manual
5.4.5

Setting - Hotline (communication settings)

This menu provides communication settings for mail, FTP, modem and phone.
These settings are mandatory for several alarm reactions in GUARD mode (Send Snapshot to FTP, Phone
call, Send SMS, Send e-mail).
E-mail Input the following information:
server, sender's E-mail address, E-mail's subject title, and body content. You may
click on the Send Test Mail button to test the settings.
Note: * indicates mandatory areas
FTP Input the following information:
server, Port, Login ID, Password, and Upload directory. According your FTP type to
enable/disable Passive mode. You may click on the Upload Test File button to test
the settings.
Note: * indicates mandatory areas.
Telephone Select the modem that the system is going to dial the info call with, and then insert
the phone number. (A modem is required for voice transition.)
Note 1. You must use a modem with voice capability.
2. You may select a Wave format file; it will be played in the phone to alarm the
person who picks up the phone call.
GSM modem Set the Port and Baud Rate of the GSM modem device, and then enter PIN code.
You can setup the interval of send SMS message. You may click on Test to send test
SMS message.
Note: The interval is set to restrict the period of two SMS. If you set as 60 min, the
SMS between 60 min would be deleted and didn't send to user.
28 of 81 ENR400_ma_inst_en_rev01