Audi TT 2007 Repair Manual page 65

– Remove both bolts -1-.
– Push connector -2- toward ignition coil, press on catch with
hand and remove connector.
– Remove ignition coil from spark plug with Ignition Coil Puller -
T40039- .
– Remove spark plugs with -3122 B- .
– Screw in new spark plugs using -3122 B- .
Note
Push ignition coils by hand into intended resources in cylinder
head cover.
– Install ignition coils by rotating slightly - they must engage no‐
ticeably.
Tightening Specifications
Spark plugs in cylinder head
2.47.5 5-Cylinder, 2.5 TFSI
– Turn the ignition off.
– Disconnect the connector -6- on the camshaft position sensor
3 -G300- .
– Remove both screws -arrows-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Maintenance Procedures - Edition 08.2011
Nm
30
Audi TT 2007 ➤
2. Maintenance Procedures
61