Audi TT 2007 Repair Manual page 45

♦ Oil drain adapter -T 40057-
Note
Follow all waste disposal regulations!
2.24.2 4-Cylinder, Gasoline Engine, 1.8 TFSI,
2.0 TFSI
– Remove the noise insulation. Refer to
⇒ "2.16 Engine Compartment Front Noise Insulation Cover,
Removing and Installing", page 28
– Loosen oil filter with Hazet Tension Band -2171-1- or Oil Filter
Wrench -3417- and remove.
Note
Follow all waste disposal regulations!
– Open oil drain plug or extract engine oil.
– Clean oil filter sealing surface on engine.
– Lubricate rubber seal lightly with oil.
– Install new filter and tighten.
– Install oil drain plug with new gasket.
– Fill with engine oil, specifications, refer to ⇒ Fluid Capacity
Tables; Rep. Gr. 03 .
Tightening Specifications
Oil filter
Oil drain plug
2.24.3 4-Cylinder, Gasoline Engine, 2.0 TFSI,
2.5 TFSI
– Remove the noise insulation. Refer to
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
⇒ "2.16 Engine Compartment Front Noise Insulation Cover,
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing and Installing", page 28
Note
Before removing oil filter, motor oil must be drained from filter so
that it does not drain onto engine and attached parts.
Maintenance Procedures - Edition 08.2011
.
Nm
22
30
.
Audi TT 2007 ➤
2. Maintenance Procedures
41