Connecting Eas; Checkpoint; Sensormatic; Connecting To The Pos System - Honeywell Stratos 2700 User Manual

The images from the video camera are shown in the upper left corner of the scanner's vertical tower.

Connecting EAS

Checkpoint®
When connecting to a Checkpoint EAS system, connect the Checkpoint EAS interlock cable (if required) to the EAS inter-
lock port on the left side of the 2700 (see
port on the underside of the 2700, shown above. Refer to
and further EAS programming information.
Sensormatic®
When connecting to a Sensormatic EAS system, connect the Sensormatic RS232 control line to the EAS interlock port on
the left side of the 2700 (see
ored antenna connectors on the underside of the 2700, shown above. Contact Tyco for further information about Sensor-
matic installation and configuration. Refer to
and further EAS programming information.

Connecting to the POS System

Step 1. Turn off the host system.
Step 2. If using a single cable, plug one end of the interface cable into the port labeled for your interface on the right side
of the Stratos bioptic:
USB: Scanner USB to Host
RS232: Scanner RS232 to Host
RS485: Scanner RS232 to Host
When using a dual cable, plug an RS232 cable into the Scale to Host port on the right side of the Stratos bioptic.
2 - 14
Checkpoint EAS Antenna Port
Device Ports on page 2-8). Connect the Checkpoint antenna cable to the antenna
Device Ports on page 2-8). Connect the Sensormatic antenna cables to the to the multi-col-
EAS Settings
EAS Settings beginning on page 10-1 for configuration codes
beginning on page 10-1 for Stratos bioptic configuration codes

Sensormatic

Antenna
Connectors