Rs232 Timeout; Host Communications Timeout Beeper; Xon/Xoff - Honeywell Stratos 2700 User Manual

RS232 Timeout

When using Flow Control with Timeout, you must program the length of the delay you want to wait for CTS from the host.
Set the length (in milliseconds) for a timeout by scanning the bar code below, then setting the timeout (from 1-65535 milli-
seconds) by scanning digits from the inside back cover, then scanning Save. Default = 1000.
RS232 Timeout

Host Communications Timeout Beeper

If you wish to hear a razz tone or a beep when a communications timeout is reached, scan one of the following bar codes.
Default = Timeout Beeper Off.
* Timeout Beeper Off
Timeout Razz
Timeout Beep

XON/XOFF

Standard ASCII control characters can be used to tell the scanner to start sending data (XON/XOFF On) or to stop sending
data (XON/XOFF Off). When the host sends the XOFF character (DC3, hex 13) to the scanner, data transmission stops.
To resume transmission, the host sends the XON character (DC1, hex 11). Data transmission continues where it left off
when XOFF was sent. Default = XON/XOFF Off.
XON/XOFF On
* XON/XOFF Off
3 - 29