Electrical Box Attachment - American Dynamics SpeedDome Ultra Camera Installation And Service Manual

5. Attach flange using washers [d] and locking
nuts [e].
6. Thread nipple [h] into the flange.
7. Thread pipe tee [g] into nipple.
8. Thread the purchased 1-1/4 inch straight
pipe onto pipe tee.
9. Slip cap [j] up onto the straight pipe.
10. Thread plate adapter [i] onto straight pipe.
11. Perform step a or b.
a.
Direct base attachment. Attach the dome's base
to the studs on the plate adapter using two M3
locking nuts [k]. Feed cables as shown.
b.
Top hat housing attachment. See "Top Hat
Housing", page 2-5.
12. Go to "Dome Setup and Attachment", page
2-18.

Electrical Box Attachment

The following procedure explains how attach the
dome's base to a standard 3.5 x 3.5 inch, or 4 x 4
inch electrical box. After completing this procedure,
go to page 2-18 for dome setup and attachment
procedures.
If the electrical box cannot support the
camera dome, ask building maintenance
to install additional ceiling supports.
Tools Required
Phillips head screwdriver
Ratchet wrench with 5.5mm socket.
Mounting Structure Required (use Kit A or Kit
B)
A) 01RHIU3x3 Standard Electrical Box Mount
a) Cover, electrical box, 3-1/2" sq.
b) Screw, M, FHP, CAD, 8-32x3/8
c) Nut, locking, M3, SS
B) 01RHIU4x4 Standard Electrical Box Mount
a) Cover, electrical box, 4" sq.
b) Screw, M, FHP, CAD, 8-32x3/8
c) Nut, locking, M3, SS
1 0500-7489-01
2 2804-1918-03
2 5826-0200-020
1 0500-7635-01
2 2804-1918-03
2 5826-0200-020
SPEEDDOME ULTRA
2-16
INDOOR INSTALLATION
Procedure
Referring to Figure Chapter 2-19:
1. Attach cover [a] to the electrical box using
screws [b].
2. Perform step a or b.
a.
Direct base attachment: Attach the dome's base
to electrical box using two M3 locking nuts [c].
Feed cables as shown.
b.
Top hat housing attachment. See "Top Hat
Housing", page 2-5.
•
3. Go to "Dome Setup and Attachment", page
2-18.
Figure Chapter 2-19. Electrical box mounting
structure
a
Base
c
b