APRON REINFORCEMENT ASSEMBLY INSTALLATION
1. When installing new parts, position each part so that the section measurement aligns to the body dimension.
2. Drill holes for plug welds before installing new parts.
3. Install in the following order: apron reinforcement lower,apron reinforcement rear, and apron reinforcement
upper.
Note
• After installing, fillet weld in location (A).
Caution
• When fillet welding, be careful of dripping, melted metal.
4. After trial-fitting new parts, make sure the related parts fit properly.
End Of Sie
PANEL REPLACEMENT
A6E981253260B02
III
A6E9812B006
III–7