Table of Contents
Advertisement
Rough Cutting of Damaged Panel
• Verify that there are no parts (such as pipes,
hoses, and wiring harness) nearby or on the
opposite side of a panel which could be damaged
by heat.
• For cut-and-join areas, allow for an overlap of
30—50 mm {1.18—1.97 in} and then rough-cut
the damaged panel.
End Of Sie
INSTALLATION PREPARATIONS
Rough Cutting of New Parts
• For cut-and-join areas, allow for an overlap of
30—50 mm {1.18—1.97 in} with the remaining
area on the body side and then rough-cut the new
parts.
Determination of Welding Method
• If the total thickness at the area to be welded is 3
mm {0.12 in} or more, use a CO
welder to make the plug welds.
I–8
EFFICIENT REPLACEMENT OF BODY PANELS
gas shielded-arc
2
MZZ2038B001
A6E203800026B02
MZZ2038B002
MZZ2038B003
Advertisement
Chapters
Table of Contents
