Lancia Ypsilon Owner's Handbook Manual page 146

fig. 12
❒ Work the jack crank F-fig. 12 to ex-
tend it until the groove G-fig. 12 on
the upper part of the jack is correctly
inserted on the lower profile H-
fig. 12 of the body in point I-fig. 12
(at approx. 72 cm from the front
wheel centre or 75 cm from rear
wheel centre);
❒ Warn anybody nearby that the car is
about to be lifted. They must stay
clear and not touch the vehicle until
it is back on the ground;
❒ Fit the handle L-fig. 12 to operate
the jack and raise the car until the
wheel is a few centimetres from the
ground;
❒ Remove the wheel cap after loosen-
ing the relevant three bolts, then
loosen the fourth bolt and remove the
wheel (only for versions fitted with
wheel cap secured by bolts).
❒ Make sure the surfaces of the space-
saver spare wheel that come into con-
tact with the hub are clean and free
from any impurities which could
cause wheel bolts loosening;
fig. 13
❒ Install the spare wheel matching
the holes M-fig. 13 with the corre-
sponding pins N-fig. 13;
❒ Using the wrench provided, fully
L0C0117m
tighten the four fastening bolts;
❒ Work the jack handle L-fig. 12 to
lower the car and remove the jack;
L0C0118m
145