Advertisement
Mezzo in a location without following the directions below will hinder the performance
of the Mezzo. With the correct PDC you will find the vocals and dialogue more realistic
and satisfying. As with any component in your system that of fers increased resolution and
detail, a careful setup is required.
There are four dif ferent setup procedures depending on your Mezzo location. The
possible Mezzo configurations are as follows:
Section 4.4—Setup #1 Mezzo on Floor
Section 4.5—Setup #2 Mezzo on Stand
Section 4.6—Setup #3 Mezzo on Custom Stand or Shelf
Section 4.7—Setup #4 Mezzo on the Hourglass Stand
Please proceed to the indicated section for your particular installation for detailed
setup instructions.
Section 4.4—Setup #1 Mezzo on Floor
The floor mounted Mezzo must be rotated up toward the listening position. This is
done by using a taller spike in the front than in the back of the speaker (see Figure 10). The
default rotation is set by using a combination of a spike, nut, and a diode. If required, ad-
ditional rotation can be achieved by using the provided 1/2" spacers between the diode
and the bottom of the cabinet (see Figure 8). The amount of rotation depends on your lis-
tening position.
Set the rotation as follows:
1. Remove the casters from the bot tom of the Mezzo. Insert the spike with nut
in their place. Turn to Section 10, table 1, locate your listening position on
the table.
2. Assemble the front spikes with the listed diode/spacer combination in Table
1 (see also Figure 5).
S
E C T I O N
W i l s o n A u d i o S p e c i a l t i e s
4 . 4 — S
# 1 M
E T U P
F
E Z Z O O N
L O O R
43
Advertisement
