Advertisement
combination until the nut is flush with the bottom (See Figure 9).
Note: Do not tighten the nut at this time. Wait until the fine-tuning has been completed
F
IGURE
for the entire system and the speaker has been leveled.
Note: Four small brass disks have been provided for use as spike pads. Place these under
the spikes to protect the finish of your floors.
3. Using provided 3/16 Allen wrench, remove the 4 setscrews from the bot tom
of the Mezzo. Keep these as they are the setscrews needed to assemble your
spikes and may be required during final setup.
4. Bolt the Mezzo to the stand using the four 3/8 – 16 threaded socket head cap
screws and washer provided (see Figure 12).
Note: Do not overtighten the bolts; a snug fit is all that is required to secure the Mezzo
to the stand.
T
T
T
T
S
S
S
S
HREADED
HREADED
HREADED
HREADED
PIKES
PIKES
PIKES
PIKES
9 – I
M
NSTALLING THE
W i l s o n A u d i o S p e c i a l t i e s
S
4 . 5 — S
E C T I O N
S
S
EZZO
TAND
PIKES
# 2 M
E T U P
E Z Z O O N A
S
T A N D
45
Advertisement
