Advertisement
M
O
'
E Z Z O
W N E R
Connection of the Mezzo to the Power Amplifier
1. Turn of f the power amplifier(s) and remove the AC power cord from the wall
outlet.
2. Lay out the speaker cables before hooking them up to the Mezzo. Make sure
that there are no kinks, twists, or right-angled bends in the cable. If you need
to turn corners, attempt to use a gradual curve as opposed to a severe right-
angled bend.
3. Connect the negative (normally black) end of the speaker cable to the high
current speaker binding post with the silk-screened "–" above it (see Figure
12).
Note: Do not overtighten the binding posts. Overtightening can cause the posts
to break off.
4. Connect the positive (normally red) end of the speaker cable to the high cur-
rent speaker binding post with the silk-screened "+" above it.
5. Plug your amplifier(s) AC power cord into the wall outlet.
Note: Always attempt to keep your set (LRC) of speaker cables the same length. This will
ensure that the signals arrive at each speaker in the proper time frame, by traveling the
same distance to each speaker.
Mezzo Setup Completed
This completes the initial setup of you Mezzo. Final system tuning and voicing should
be performed as outlined in Section 5. Section 5 will evaluate your entire speaker setup
and allow you to make small modifications in speaker rotation and location that will great-
ly improve the performance of your multi-channel audio or home theater system.
50
M
S
A N U A L
W i l s o n A u d i o S p e c i a l t i e s
Advertisement
