Advertisement
M
O
'
E Z Z O
W N E R
sound, you should raise the front spikes of your Mezzo. This can be done by removing the
front spikes and replacing them with the spike assembly as shown in Figure 20 above. Do
as follows:
• Screw the spike and nut into the diode.
• Screw the 3/4" setscrew into the front spike holes in the stand.
• Thread the spike assembly onto the set screw.
Resetting the Propagation Delay correction (PDC)
Once the final rotation has been determined, you will need to reset the PDC. If you
have raised the speaker by adding a diode or 1/2" spacer, read the PDC from the table that
matches your current spike configuration in Section 10.
Every system has a unique time and phase character, which can af fect the PDC ac-
curacy. Because of this, you may find that sliding the tweeter forward or backwards one or
two positions increases the clarity and correctness of your Mezzo. If you like, experiment
with the tweeter position and lock it in position when you find the location you feel to be
most accurate.
Integrating the WATCH Surround Channels
• Follow the processor instructions on level adjustment. Adjust the level on
the Surround channels so they match in level with the front channels.
• Play a DVD that has a scene with something moving around the room.
Listen for the correct spacial imaging. A correctly adjusted Surround chan-
nel will have good imaging characteristics, will be seamlessly blended, and
should be just as transparent as the front channels.
• Adjust the rotation of the Surround channel until you find the best integra-
60
M
S
A N U A L
W i l s o n A u d i o S p e c i a l t i e s
Advertisement
